相关文章

如何解决板式家具生产线过热的问题

如何解决板式家具生产线过热的问题

板式家具生产线的发热主要是因为内部部件和材料高速运转所产生的,是不可避免的,因此,要解决这个问题,就需要我们从提高散热效果方面来入手了。

Board type furniture production line of fever mainly because of the internal components and materials produced by high speed, is inevitable, therefore, to solve this problem, you need we to start from the aspects of increase the cooling effect.

最简单易行的办法便是设置专门的冷却系统。

The most simple way is to set a special cooling system.

在电机定子与壳体连接处设计循环冷却水套,水套用热阻较小的材料制造,套外环加工有螺旋水格。电机工作时,水槽里加入循环冷却水,为加强冷却效果,冷却水的入口温度应严格控制,并有一定的压力和流量。

In the motor stator and shell joint design cycle cooling water jacket, water to use the materials of thermal resistance small, set of outer ring processing spiral water. Motor work, join the circulating cooling water in the sink, to strengthen the cooling effect, cooling water inlet temperature should be strictly controlled, and has a certain pressure and flow rate.

另外,为防止电机发热影响主袖轴承,主轴应尽量采用热阻较大的材料,使雕刻机电机转子的发热主要通过气隙传给定子,由冷却水吸收带走。

In addition, in order to prevent the motor heat effects main sleeve bearing, spindle should try to use thermal resistance material, make mechanical and electrical machine carving heat mainly through an air gap to the stator, rotor absorbed by the cooling water away.

钻头在钻孔时容易出现爆边现象是怎么回事?钻头自身如果没有倒锥、钻头自身不同轴(跳动大)、钻头小尖(割刃)比中心尖高,这些原因都能造成钻孔时孔口爆边现象。

Easy to appear when drill in drilling blasting edge phenomenon is how to return a responsibility? Bit itself if there is no back taper, their own bit not coaxial (beat), little bit sharp pointed high (cutting edge) than center, these reasons can cause hole orifice detonation phenomenon.

解决的办法就是严格检验以上提到的各个参数,做到符合产品图纸要求。

The solution is to strict inspection all parameters mentioned above, to conform to the requirements of the product drawings.